SPI NOR Flash BY25D80ASTIG Boya electronic in stock

BY25D80ASTIG is 8M-bit Serial Peripheral Interface (SPI) Flash memory, and supports the Dual SPI: Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO). The Dual Output data is transferred with speed of 108Mbits/s. The device uses a single low voltage power supply, ranging from 2.7 Volt to 3.6 Volt.

BY25D80ASTIG FLASH NOR (SLC) Memory Series 8Mbit SPI – Dual I/O 108 MHz 7 ns 8-SOP 8 MBIT, 3.0V (2.7V TO 3.6V), -40℃ to +85.

Additionally, the device supports JEDEC standard manufacturer and device ID.

In order to meet environmental requirements, Boya Microelectronics offers an 8-pin SOP 150-mil, 173-mil or 208mil, an 8-pad USON 3×3-mm, an 8-pin USON 3×2-mm and other special order packages, please contacts Boya Microelectronics for ordering information.

Serial Peripheral Interface (SPI)
– Standard SPI: SCLK, /CS, SI, SO, /WP
– Dual SPI: SCLK, /CS, IO0, IO1, /WP

Read
– Normal Read (Serial): 55MHz clock rate
– Fast Read (Serial): 108MHz clock rate
– Dual Read: 108MHz clock rate

Program
– Serial-input Page Program up to 256bytes

Erase
– Block erase (64/32 KB)
– Sector erase (4 KB)
– Chip erase

Program/Erase Speed
– Page Program time: 0.7ms typical
– Sector Erase time: 100ms typical
– Block Erase time: 0.3/0.5s typical
– Chip Erase time: 8s typical

Flexible Architecture
– Sector of 4K-byte
– Block of 32/64K-byte

Low Power Consumption
– 20mA maximum active current
– 5uA maximum power down current

Software/Hardware Write Protection
– Enable/Disable protection with WP Pin
– Write protect all/portion of memory via software
– Top or Bottom, Sector or Block selection

Single Supply Voltage
– Full voltage range: 2.7~3.6V

Temperature Range
– Commercial (0℃ to +70℃)
– Industrial (-40℃ to +85℃)

Cycling Endurance/Data Retention
– Typical 100k Program-Erase cycles on any sector
– Typical 20-year data retention